BDS 3" Upper Control Arm Lift Kit 20-21 Chevy/ GMC 2500HD 3500HD w/ Fox Shocks

Description

BDS 3" Upper Control Arm Lift Kit 20-21 Chevy/ GMC 2500HD 3500HD w/ Fox Shocks
BDS 3" Upper Control Arm Lift Kit
THIS LISTING IS FOR ONE (1) BDS LIFT KIT - PART# 760FS
1 - BDS-011310
Tubular Upper Control Arm Kit
1 - BDS-011218
Rear 2" Block Kit Without Overload Springs
2 - BDS-FOX-985-24-240
Fox 2.0 Performance Series Front Shocks
2 - BDS-FOX-982-24-758
BDS Fox 2.0 Performance Series Rear Shocks
Description:
At the heart of this new system is a pair of heavy duty tubular upper control arms (UCAs) designed for improved strength and suspension travel. These new control arms are built from thick wall 1.5" DOM tubing, and use an indexed ball joint cup to reposition the upper ball joints to allow more droop travel. These arms come fully assembled right out of the box with high quality greaseable ball joints and rubber bushings for long life, quiet operation and superior corrosion resistance over uniballs and heims. Along with the control arms, a pair of indexed cast steel torsion bar keys are supplied up front to lift vehicle. A small differential relocation kit is supplied to correct CV axle operating angles without effecting ground clearance. To eliminate sway bar interference, a pair of sway bar relocation brackets is used which maintains proper operating angle. In the rear a 2" block and u-bolt kit is used to create a level to slightly tail high stance when unloaded. Rounding out these kits are a pair of specially tuned FOX 2.0 performance series IFP shocks ready to soak up the terrain. Take your HD to the next level with BDS Suspension.
Features:
Heavy duty tubular upper control arms
High quality greasable ball joints
Clevite rubber frame bushings
Upper ball joints allow more droop travel
Designed for simple bolt on installation
Kit allows clearance for up to 35" tires
Important Kit Notes:
Disassembly/assembly of the factory torsion bar system requires the use of a special unloading tool. The GM specified tool # CH48809
Compatible with gas or diesel models
Compatible with AT4 models
Some minor trimming may be necessary to fit certain wheel/tire combination. This is normal with most aftermarket tire/wheel fitment on Chevy/GM trucks and typically consists of trimming the bottom edge of the inner fender shrouds and/or lower corner of front bumper valance. As a rule of thumb, deeper backspacing and shorter/ narrower tires will reduce/eliminate trimming required. Further trimming tips are included at the end of this instruction sheet
Not Compatible with DRW models
Applications:
2020 - 2021 - Chevy Silverado 2500HD & 3500HD (2 & 4wd)
2020 - 2021 - GMC Sierra 2500HD & 3500HD (2 & 4wd)
Not Compatible with DRW models
Part# BDS-760FS
Powered by SixBit's eCommerce Solution